Jeep Modified Stroker; Bosch Gen III, 30lb, 36lb - Matched

Bosch Gen III EV-14 flow-matched fuel injectors

• List Price Includes: One (1) fuel injector
• Multiple injectors delivered in flow matched sets.

Flow-rate Options:

• 30lb - 310cc
• 36lb - 380cc

FLOW CHART: Each set is sold with a complete flow-data chart indicating individual static flow rates at 3.0, 3.5, and 4.0 BAR. As well as 3.0 BAR dynamic pulse testing for idle (15% duty-cycle) and 50% duty-cycle. Along with a complete dead time off-set (latency) table. Flow matching was done with industry-standard equipment of the highest quality.
The tests were performed at varying temperatures to achieve realistic results. Linear tuning with excellent low-end, and idle rpm.

SPECIAL NOTE TO OUR E85 USERS:
Ethanol tends to "dry" the orifices. Customers should be made aware that this can be a problem with some fuel injectors. And may cause a "sticking" problem. It is suggested that a tank of 91-98 octane gasoline be run to every 5 or 6 tanks of Ethanol to re-lube not only the fuel injectors, but the entire fuel component system. This is also considered to be good maintenance, but not essential, for stainless steel based fuel injectors.

Injector Body Design: EV6, black composite plastic.

Injector type: EV6, saturated

Fuel Nozzle: Multi-hole for maximum atomization

Flow rates:  30lbs/310cc, 36lbs/380cc

36 bs/hr at 43.5 PSI

Dead time (latency): 0.85 ms at 14 volts

Electrical connector type: U.S. CAR

Length: 3 inches, 74 mm

Body Diameter: 19 mm

Orings: Viton, Top and bottom, 14 mm

Resistance: 14.5 Ohms

(All fuel injector specifications meet or exceed the manufacturer's specification standard).