SET, 1000cc 96lb - Fiveo Asphalt Series, 2.5 Ohms, Flow-Matched, LS-Fit

Complete set of 8 fuel injectors
High-performance, low impedance - 1000 cc/min fuel injectors

• New "ASPHALT" Series; flow-matched, peak and hold fuel injectors

• Custom manufactured, American-made fuel injectors

• Rated FLEX for all-fuels ; including gasoline (MTBE), E-85, all oxygenated fuels.

FIVEOMOTORSPORT FUEL INJECTORS are custom-manufactured in small-quantity batches to achieve the highest quality product. Our injectors are all-fuels rated; including gasoline (MTBE), and E-85. The finished injectors are then flowed and inscribed with a control number. Data is recorded for each injector. The fuel injectors are then grouped into matched sets ready for shipping.

FLOW CHART: Each set is sold with a complete and unique flow-data chart indicating individual static flow rates at 3.0, 3.5, and 4.0 BAR. As well as 3.0 BAR dynamic pulse testing for idle (15% duty-cycle) and 50% duty-cycle. Along with a complete dead time off-set (latency) table. Flow matching was done with industry-standard equipment of the highest quality.
The tests were performed at varying temperatures to achieve realistic results. Linear tuning with excellent low-end, and idle rpm.
Fiveo is the only fuel injector seller that can claim this level of technology.

SPECIAL NOTE TO OUR E85 USERS:
Ethanol based fuels tend to "dry" the fuel injector outlet orifices. Customers should be made aware that this may cause a "sticking" problem in fuel injectors that sit idle for a prolonged period of time. It is suggested for applications running high ethanol content based fuels, to periodically incorporate into their fuel-system-maintenance a drop of light petroleum-based lubricant for each fuel injector. This is also considered to be good maintenance, but not essential, for stainless steel based (Black-Ops Series) fuel injectors.  It should also be noted that for optimum performance the entire fuel system should be made up of ethanol approved materials including all fuel lines/fuel pump/fuel filter, etc.

Flow rate:
We use the industry standard Heptane as our testing agent.
1000 cc/min at 43.5 psi (3.0 bar)
1075 cc/min at 50.8 psi (3.5 bar)
1155 cc/min at 58.0 psi (4.0 bar)

Solenoid Resistance: 2.5 Ohms

This injector will function at rail pressures in excess of 101 PSI, 7 bar.

Excellent low pulse width response with predictable response down to 1.5 ms.

Excellent atomization for modern multi-valve engines

This injector will require no more than a 1% trim for easy tuning

Injector type: EV1

Application: Super-street and racing, naturally- and forced-aspirated engines

Fuel Delivery: Single-Pintle

Electrical Connector: EV1, minitimer

Spray type: wide cone, maximum atomization

Length: 3 inches, 74 mm

Body Diameter: 22 mm

O-rings: Viton, upper and lower; 14.5 mm

Resistance: 2.5 Ohms

Fuel types: Gasoline, Methanol, E85, E25, E10

We are fuel injector experts - email with your questions