Bosch, 550cc Injector, 1989-1991, Mazda RX-7 Turbo, N37013250

You are purchasing a brand new EV14 fuel injector - Original Equipment Replacement for p/n N37013250
Old Denso p/n: 195500-2020

List price includes:  a single (1) fuel injector with o-rings and seals

FLOW CHART: delivered with a complete flow-data chart indicating individual dynamic and static flow rates at 3.0, 3.5, and 4.0 BAR at 15%, 50% and 100% duty cycle for each injector, along with a complete dead time (latency) table. Flow testing and matching was done with industry-standard equipment of the highest quality.
The tests were performed at varying temperatures to achieve realistic results.

Our injectors are custom-manufactured from brand new American/German/Japanese-made fuel injector "cores" in large-quantity batches to achieve the highest quality product. The resulting sets are all-fuels rated; including gasoline (MTBE), and E-85. The finished injectors are then flow tested and inscribed with a control number. Data is recorded for each injector. They are then sealed and placed in matched sets ready for shipping.
You don't get this kind of technology from an OE injector.
No adapters, No wiring issues, no soldering.

Manufacturer flow rates do vary slightly from set to set.
You get a custom flow matched set that will not vary more than 1%, or less than 10cc across the set.
But the most important statistic is the pulsed, dynamic flow rate on this set of injectors is nearly perfect.

Injector type: Filterless, EV14, composite plastic, saturated
Electrical connector type: Sumitomo
Overall length: 65 mm
Oring to Oring on Center: 52 mm

Flow rate:
550cc/min at 3.0 BAR
Latency (Dead Time):
0.75 ms at 14 volts
Tested Resistance: 12.5 Ohms
Voltage: 8-15 Volts, Nominal 13.5 Volts
Amperage: 1.0 Amps
Pressure: Min. 36 PSI (2.5 bar), Max. 130 PSI (9 bar)
Excellent fuel atomization - Excellent linearity
Low end pulse width accurate to within 1% down to 2ms.
This Bosch injector will not require more than 1% trim
All 14.5 Viton O-rings Included for installation.

SPECIAL NOTE to our customers:
All orings are supplied for installation.
(All fuel injector specifications meet or exceed the manufacturer's specification standard).